Hi,
I would like to report a very strange fault. I wonder how users can configure diseqc switch at all.
I have a 10 port diseqc 1.1 switch with 7 LNBs connected. After setting up the system and performing initial scan I observed that many DVB muxes are not available and others appear on different satellites where they should have. Strange. I found that LNB switch does not follow the settings on Satellite config page. I played an hour to define same mux data on all inputs and discover which satellite can be received with wich diseqc settings.
This is what I discovered.
TVH settings - Actual LNB input
1 - > 5
2,3 - > 9
4 - > 2
5 - > 6
6,7,8- > ?
9,10 - > 7
11 - > ?
12 - > 4
13,14- > 8
I tried to find an algorithm between the two columns but these mapping looks totally random.
How this mess up possible???
(The LNB input numbers are 100% OK. It is my existing config.)
Regards,
