Hi,
Can you remove "monitor signal quality", and also "skip service availability check" .
(in some cases, the "monitor signal quality" makes the perceived signalstrength go to zero, as seems to be the case with some of your muxes).
Then restart, and see if some services come up .
Are the mux-frequencies and settings correct?
Alex.
Dennis Pun wrote:
> Could any please help?
>
> i am using QNAP TS-119(firmware 3.6.1), TVtuner - MyGica D689 (
http://www.linuxtv.org/wiki/index.php/MyGica_D689)
>
> I can successfully install the tvheadend (3.3.183~g5d2197c).
>
> But i
CAN NOT "Map DVB services to channels" (It is greyed.)
>
> From TV Adapters scanning, sometime it shows Signal Strength as 60% on some frequency...but still no service
>
> Here is my setting
> Configuration -> TV Adapters ->
>
Network by location: Hong Kong
>
> Adapter configuration ->
>
Autodetect muxes: x (checked)
> Skip initial scan:
>
Idle scanning: x (checked)
> Close device handle when idle:
>
Skip service availability check when mapping: x (checked)
> Use SID as channel number during mapping:
>
Monitor signal quality: x (checked)
> Full mux reception: off
> Disable PMT monitoring:
> Original Network ID: 0
> Extra priority: 0
>
> Thank you very much