Jeroen Bogers wrote:
> The issue with your OSCam configuration is that the CAID you used for your newcamd port is not the same as the CAID the card uses. Your card is configured for CAID 2600 (oscam.server, [reader] section, caid and ident values).
>
> You configured newcamd for caid 0604 (ident 0604:000000 to be exact). I'm guessing you copied some example from somewhere. Change the 'port' line for [newcamd] in oscam.conf to match the ident from the [reader] section and you should be on your way.
>
> [...]
>
> TL;DR: Make sure that you use a consistent CAID and provider id in all your configurations, including the newcamd config.
Or active MGCAMd client and pass all CAID's no meter
Enable mgcamd extended newcamd protocol, allowing for a single connection to work with multiple providers, default:0
Example:
mgclient = 1 # (enabled)
mgclient = 0 # (disabled)
Default:
mgclient = 0
then with config as fallow
[newcamd]
port = 15050@0001:000000
key = 0102030405060708091011121314
mgclient = 1
no problem to use it with more then one CAID