Robin Brouwer wrote:
> I guess this will be a bit offtopic, but I doubt anyone will care...
>
> It depends on how you setup linux. I'm using Ubuntu 20.04, which comes with kernel drivers for my tuner. (I only had to recompile the kernel for setting CONFIG_DVB_MAX_ADAPTERS to something higher than 8!)
>
> After that I did: [...]In the src/Makefile file 1 line should be changed (hence the nano command). DDCI=0 should be changed into DDCI=1, which made the section at the top end up looking like:
> [...]
> If for you things like DVBCSA or DVBAES or DVBCA are set to 0, it's time to apt install some extra libs and start again with ./configure! There's also a possible DDCI_TEST=1, which you could add below DDCI. Then minisatip should work in case you use DD's drivers.
>
> After compiling is completed, follow the steps in tools/autostart.readme for installing it into Ubuntu.
>
> And then finally you will of course disable all tuners in Tvheadend and enable those coming from minisatip!
Hi Robin,
How have you started the ./minisatip? Have you added any options for it?
I have build the minisatip (with the DDCI=1), disabled all tuners at the TVH and started ./minisatip, then tried to configure sat2ip tuner(s) at the TVH. Free to Air channels works well, but not the Encrypted. Card is
Digital Devices OctopusCI S2 Pro Advanced - Twin CI and Twin DVB-S2 Tuner for PCIe Slot