Hi ullix,
You where right about the need for one mux to start things of.
Now:
Today I installed tvheaend on a raspberry pi and the moment i was done with the setup of Tvheadend, i found 115 muxes and 337 channels.
GREAT SUCCESS.
So, it does seem like there is something odd going on with the VM i was running to test this out.
The good thing is that now i know its working and its doing what it is suppose to.
Again, I got the help from Mark Clarkstone, who could guide me in the right direction over irc. Thanks for that :)
But... all is not well :)
Some of the muxex it found gave the error:
service instance is bad, reason: No input detected
But when i plug my cable back into my reciver, I can see the channels on that mux just fine, no problem.
So, what could be the reason for this?
Could it be that the pi is not strong enough for the task?
I think it might need a new thread, but not sure if that is against the rules?
Kind regards
Ps, i will do a small tut on the "Triax Tss 400 and Tvheadend" so others dont need to go through the same things as me :)