Project

General

Profile

TBS6902 - no input source available

Added by KenyBDG K. 5 months ago

From few years I'm using TBS6902 with TVH 4.2.8-34 and everything work well.
Because I can watch only two channels simultaneously I decided to buy same TBS6902.
After installation the card has been detected by TVH without any issue, but when unfortunately I cannot watch anything using this new card.
I've noticed on TVH log,

2021-03-09 20:02:32.973 subscription: 00C0: No input source available for subscription"

Maybe card is broken, but before I send back to seller, I'd like to be sure that everything is ok on my side.
I've been testing also just one card to be sure that power supply is ok, but there is no matter, if I use one or both card.
Of course old one TBS6902 work fine.

12.JPG (39.8 KB) 12.JPG

Replies (19)

RE: TBS6902 - no input source available - Added by Ron L 5 months ago

The red dots on the last two adapters indicate that they have not been enabled in the configuration.

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

Yes you are right but I disabled this adapters because they caused problems

RE: TBS6902 - no input source available - Added by Ron L 5 months ago

If you remove the old card and use only the new card it does not work?

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

Yes, doesn't work.....I used also same PCI-E port.... no succeed

RE: TBS6902 - no input source available - Added by Ron L 5 months ago

That sounds like a defective device then.

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

It seems that you are right..... :( I was hoping I forgot to configure something..

RE: TBS6902 - no input source available - Added by Ron L 5 months ago

As long as the network is assigned to the device it should be used. Some of these dual tuner devices needed some extra config with the linked input setting but if it's working with the old card then your settings must be correct.

RE: TBS6902 - no input source available - Added by saen acro 5 months ago

Reinstall TBS driver
Test is it work with some "elec" distro on usb drive.

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

I've reinstalled drivers couple of time, no succeed.
But I'll try to install some "elec" distro, I'm using TVH on Proxmox, so it's shouldn't any problem with installation "elec" distro (I hope so)

RE: TBS6902 - no input source available - Added by Ron L 5 months ago

They are identical cards. If one works then you pull it out, install the other and it doesn't work then that isn't a driver issue.

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

The seller replaced the card with a new one, but no improvement, issue is the same. I've no idea what is the root cause...

RE: TBS6902 - no input source available - Added by saen acro 5 months ago

What hardware you use?
What OS

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

Mainboard GA-B85M-D3H
Processor i7 4790
Ram - 16GB

OS - Debian (Proxmox VE) Tvhedaend is installed on container LXC

RE: TBS6902 - no input source available - Added by Ron L 5 months ago

Have they changed out any of the chips on the newer cards?

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

It seems that both card have the same chipset

new.JPG (57.6 KB) new.JPG new
old.JPG (74.5 KB) old.JPG old

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

I've noticed sth suspcious

[email protected]:~/media_build# lspci -vvv | grep 6902
        Subsystem: Device 6902:0002
pcilib: sysfs_read_vpd: read failed: Input/output error
        Subsystem: Device 6902:0003

RE: TBS6902 - no input source available - Added by saen acro 5 months ago

Install LibreElec on USB Drive and test, isolating virtualization.

RE: TBS6902 - no input source available - Added by KenyBDG K. 5 months ago

I've been talking with TBS support.
TBS6902 has a new SoC which need new drivers, unfortnately they need some time to prepare drivers for this SoC, they will probably deliver it next Monday...... (I hope)

RE: TBS6902 - no input source available - Added by KenyBDG K. 4 months ago

Update from TBS

Hi 

It is the HV voltage control reversal problem , when you set "H", the voltage is 13V, set "v" ,the voltage is 18V. so you just need setting the opposite voltage ,you will get the channel.
later i will fixed it.
Thanks for your feedback.
Best Regards

    (1-19/19)